济南力诺瑞特太阳能销售服务中心
地址:济南市天桥区粟山路76号(药山派出所对面)
电话:0531-85715890
手机:15665707182
网站:http://www.sdlntyn.com
联系人:江经理
当前位置:首页 - 新闻中心新闻中心
济南太阳能售后服务中心告诉你排污清洗的步骤!
来源:http://www.sdlntyn.com 发布时间:2019-7-18 17:10:16 浏览次数:85
因为热水器几乎是每一个家庭都需要的,所以对于热水器的使用,如果热水器使用比较久的话,就必须要进行清洁,但是清洁的工作是属于一个比较难的问题,而且排污口是排污的主要通道,也是必须要清洁的地方,下面济南太阳能售后服务中心就给大家说说热水器排污清洗的步骤!
Because the water heater is almost needed by every family, so for the use of water heater, if the water heater has been used for a long time, it must be cleaned, but the cleaning work is a relatively difficult problem, and the sewage outlet is the main channel for sewage discharge, and also the place that must be cleaned, Jinan below. Solar energy after-sales service center will tell you about the steps of water heater sewage cleaning!
1、关闭电热水器的总电源,关闭电热水器的进冷水开关,把放水歧管打开,顺时针开大。放水歧管就是家里放水的水龙头,顺时针开大,就是出的全是热水的位置。
1. Turn off the main power supply of the electric water heater, turn off the inlet cold water switch of the electric water heater, open the drainage manifold, and open clockwise. Drainage manifold is the faucet that puts water in the house, which opens clockwise and gives out all the hot water.
2、把准备好的盆子放在排污口的下面。一般家用的电热水器的储水量都在50L左右。自家的电热水器容量多少可以查看说明书。依容量多准备几个盆子或桶,不然会弄得地板污水横流。
2. Put the prepared basin under the sewage outlet. The water storage capacity of household electric water heaters is about 50L. The capacity of your electric water heater can be consulted in the instructions. Prepare more pots or buckets according to the capacity, otherwise the floor sewage will flow across.
3、用扳手顺时针拧开排污口螺母,开始拧的时候不要太用力,要慢慢加力。因为排污口螺母里面连着一根镁棒。用力过猛,有可能镁棒断到热水器里面。这里的扳手可以是开口的、梅花的、套筒的。都可以。活动扳手不是很好使。只要扳手大小和螺母相匹配就可以了。

3. Open the sewage outlet nut clockwise with a wrench. Don't use too much force at the beginning of the screw, but work harder slowly. Because there is a magnesium rod attached to the sewage outlet nut. If you push too hard, maybe the magnesium rod will break into the water heater. The wrench here can be open, plum blossom and sleeve. Fine. The movable wrench doesn't work very well. Just match the size of the wrench with the nut.

济南太阳能

4、把排污螺母拿下来,污水就从排污口流下来了,是不是很脏呢?我当时弄得时候,先出了一点黑色的污水,然后就是夹杂着很多水垢的水。
4. Take down the sewage nut, and the sewage will flow down from the sewage outlet. Is it dirty? When I got it, I first produced a little black sewage, then a lot of scaly water.
5、放完污水后,把热水器的进水管打开,放些冷水进去冲刷冲刷,直到流出的水干净为止。关闭进水管,把排污螺母拧上。打开进水管,开始往热水器中储水,直到放水歧管有水流出。就说明水储满了。
5. After discharging the sewage, open the intake pipe of the water heater and flush it with some cold water until the outflow water is clean. Close the intake pipe and screw the drainage nut on. Open the intake pipe and start storing water in the water heater until the discharge manifold has water flowing out. That means the water is full.
6、关闭放水歧管,插上电热水器电源,收尾,打扫卫生。大功告成。
6. Close the drain manifold, plug in the power supply of the electric water heater, finish and clean up. Be accomplished.
感谢您的阅读与观看,本文的精彩内容来自:济南太阳能售后服务中心,我们会有更多的精彩内容继续为您呈现,详情请点击:http://www.sdlntyn.com
Thank you for your reading and watching. The wonderful content of this article comes from: Jinan Solar Energy After-sales Service Center. We will continue to show you more wonderful content. For more details, please click: http://www.sdlntyn.com.